This USB 2.0 is used to communicate with the RGB hub. You may need two additional cables to attach, where one goes to the SATA power output connector from PSU, and the other goes to the motherboard USB 2.0 header. Remember to connect female connectors with holes from the lightning units into the splitter.Īfter connecting the cooler master software connections to the RGB controller hub, you have to check all the connections again to ensure that all the links are well matched. In the RGB connectors, there will be proper markings showing where you have to connect which cables.Īnd don’t forget to follow the lines and markings to make appropriate connections. There is a line with four holes and pins in the RGB and splitter cables. The easier solution to pairing the cooler master RGB software with the motherboard is to use the 3 in 1 RGB splitter. People get it hard and cannot find the solution to it. When people begin to pair a cooler with the other motherboard, connecting the USB cable and the RGB cables from the cooler to the motherboard becomes very tough. If you can switch the USB connector to a USB 2.0 connector, the problem will be solved, and it will start to run as well.īy changing the connector, you should plug off all the connections and then again plug them on.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |